question

radhamanickam avatar image
radhamanickam asked ·

Clover Flex/SNPD Pair using Serial Number

Hello,


I am trying to connect the Clover Flex device using the Endpoint containing Serial number using the Secure network pay display.

I am able to connect using IPAddress, but when i tried Serial number endpoint, its not at all connected.

Is there a way to fix this issue?


Thanks.

Clover Flexsemi-integrationssecure network pay display
4 comments
10 |2000 characters needed characters left characters exceeded

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

It works fine for me, this may have something to do with your network.

0 Likes 0 · ·
radhamanickam avatar image radhamanickam David Marginian ♦♦ ·

We are using the devkits to connect. Will it matter?

And this is the Endpoint we are using to connect,

wss://Clover-{SerialNumber}.local.:12345/remote_pay

0 Likes 0 · ·
radhamanickam avatar image radhamanickam David Marginian ♦♦ ·

And we are getting the "OnDeviceDisconnected" event fired back from the device in the example POS.

0 Likes 0 · ·

I have a devkit as well, it is working fine. Receiving the disconnected event would be expected if you can't establish a connection. As I said, this may be a networking issue.

0 Likes 0 · ·

0 Answers

· Write an Answer

Write an Answer

Hint: Notify or tag a user in this post by typing @username.

Up to 2 attachments (including images) can be used with a maximum of 512.0 KiB each and 1.0 MiB total.

Welcome to the
Clover Developer Community